Brightsign BSNEE Installation Guide v.4.0 Manual de usuario descargar pdf (Pagina 12)

BSNEE Installation Guide

PRE-INSTALLATION

After installing the required software, you will need to take some preliminary steps before

installing BSNEE. Please complete all steps before moving on to the Installation section.

Mail Server

A mail server (STMP) is used to send application notifications such as error logs, new/restored

passwords, and user creation notifications. These notifications are sent to end users and

administrators. To set up the mail server during installation, you will need to prepare the

following parameters:

• Server Name: e.g. localhost

• User Name: e.g. mailUser

• Password

Note: The User Name and Password may be empty if the mail server supports it.

• FROM Address: e.g. from@mydomain.com

• Port: 25 (by default)

• TLS: This is disabled by default.

Base Domain Name

BSNEE requires a Base Domain Name, which will be used to manage the application once it is

installed. Four separate strings will be used by different internal services to regulate BSNEE:

• Website

• Device Handlers

• Web Services

• Web Storage

Note: Each service uses its own sub-string to build the complete connection string.

During Step 6 of the installation process, you must enter the Base Domain Name. There are

no supported IP addresses, so you must input only the domain name. The other strings will be

automatically generated using the domain name.

BSNEE will not function properly until all strings are registered in the DNS, pointed to your

BSNEE server IP address, and are resolvable by both server and client. You may do this prior

to, or immediately after, installation. The example chart below shows which DNS records you

need to register. It uses mydomain.com as the BSNEE Base Domain Name and 10.0.0.1 as

the IP address for the BSNEE server.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sin comentarios

Brightsign BSNEE Installation Guide v.4.0 Manual de usuario Pagina 12