Brightsign Object Reference Manual (FW 5.1) Manual de usuario descargar pdf (Pagina 175)

167

below bytes_per_second when averaged over period_in_seconds. Note that if the transfer is over the Internet, you

may not want to set period_in_seconds to a small number in case network problems cause temporary drops in

performance. For large file transfers and a small bytes_per_second limit, averaging fifteen minutes or more may be

appropriate.

• SetProxy(a As String) As Boolean

• SetFileProgressIntervalSeconds(interval As Integer) As Boolean: Specifies the interval (in

seconds) between progress events when an individual file is being downloaded. Setting the interval to -1 disables

all progress events. Setting the interval to 0 specifies that events should be generated as often as possible, though

this will slow down the transfer process. If the interval is set to 0 or any positive integer, events will always be

generated at the start and end of the file download irrespective of elapsed time. The default interval is 300 seconds.

• SetFileRetryCount(count As Integer) As Boolean: Specifies the maximum number of times each file

download will be retried before moving on to the next file download. The default retry count is five.

• SetRelativeLinkPrefix(prefix As String) As Boolean: Specifies a prefix that will be appended to the

front of relative links in the sync spec. Normally, this method is used to make file:/// URIs drive agnostic, but it can

also be used to reduce the size of the sync spec if all files are stored in the same place. Non-relative links are not

affected by this method.

• BindToInterface(interface As Integer) As Boolean: Ensures that the HTTP request goes out over

the specified network interface (0 for Ethernet or 1 for WiFi). The default behavior (which can be specified by

passing -1) is to send requests using the most appropriate network interface, which may depend on the routing

metric configured via the roNetworkConfiguration object. If both interfaces are on the same layer 2 network, this

method may not work as expected due to the Linux weak-host model.

The ifMessagePort interface provides the following:

• SetPort(a As Object)

The ifUserData interface provides the following:

• SetUserData(user_data As Object): Sets the user data that will be returned when events are raised.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 340 341

Brightsign Object Reference Manual (FW 5.1) Manual de usuario Pagina 175