Brightsign BrightAuthor User Guide v.4.1.1 Manual de usuario descargar pdf (Pagina 144)

136

Chapter 9 – Customizing Presentations

Import/Export User Events

These actions allow you to transfer User Defined Events between presentations. This is useful when creating multiple

presentations that use many of the same or similar events.

RF Channel Scanning

Before you can use the RF In state to display live video, you will first need to perform a channel scan. You can perform a

channel scan either as an independent action (similar to setting up a player) or as a state in an interactive presentation.

The user interface for the Scan Setup window is the same for both methods. See Chapter 3 > Tuner Scan for more

information about using channel scanning in an interactive presentation.

1. Navigate to Tools > Setup RF Channel Scan.

a. Channel Map: Select QAM, ATSC, or ATSC and QAM (consult your

service provider for details).

b. Modulation Type: Select QAM 64, QAM 256, or QAM 64 and QAM

256 (consult your service provider for details).

c. First RF Channel (optional): You can choose to limit the range of the

channel scan by selecting the first channel to scan.

d. Last RF Channel (optional): You can choose to limit the range of the

channel scan by selecting the last channel to scan.

Note: Each channel takes approximately one second to scan. Specifying upper and lower limits will reduce the

amount of time it takes to perform the scan. You should only use these two options if you are familiar with the

channel map of the cable source.

2. Click OK and write the channel scan settings to an SD card or USB drive.

3. Power off your BrightSign XD1230.

4. Insert the SD card or USB drive into the player and power it back on. The progress of the channel scan will be

displayed on screen.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 189 190

Sin comentarios

Brightsign BrightAuthor User Guide v.4.1.1 Manual de usuario Pagina 144