Brightsign BrightAuthor User Guide v.4.1.1 Manual de usuario descargar pdf (Pagina 88)

Chapter 4 – Making a Presentation Interactive

• Increment: Specifies how much the volume level increases with each interaction. Select the Analog, HDMI, or

SPDIF connector in the dropdown list.

• Decrement: Specifies how much the volume level decreases with each interaction. Select the Analog, HDMI, or

SPDIF connector in the dropdown list.

• Mute: Turns the connector audio output off. Use the checkboxes to select among the Analog, HDMI, and SPDIF

connectors.

• Unmute: Turns the connector audio output on. Use the checkboxes to select among the Analog, HDMI, and SPDIF

connectors.

Zone Volume: Sets the volume for a zone. Note that the Connector Volume command takes precedence over the Zone

Volume command when both are active in a presentation.

• Set: Specifies an absolute volume level for a zone. Use the dropdown menu to select the zone to which this

command applies and enter a volume value between 0 and 100.

• Increment: Specifies how much the volume level increases with each interaction. Use the dropdown menu to

select the zone to which this command applies and enter an increment amount.

• Decrement: Specifies how much the volume level decreases with each interaction. Use the dropdown menu to

select the zone to which this command applies and enter a decrement amount.

Send: Sends information using the following methods:

• Send Zone Message: Triggers a Zone Message event with the same command parameter as the Send Zone

Message command.

• UDP: Sends a command to the device using UDP protocols.

• Send IR Remote: Sends a command via the 3.5mm IR Out port (4K and XD models only).

• Send IR Remote (Pronto): Sends a command using Pronto Hex Code (PHC) via the 3.5mm IR Out port (4K and

XD models only).

• Send string (EOL): Sends the specified string to the specified serial port. This command adds a carrier return at

the end of the string.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 189 190

Sin comentarios

Brightsign BrightAuthor User Guide v.4.1.1 Manual de usuario Pagina 88